mainframe
- Τα περιεχόμενα μου
- Όλα τα μηνύματα
- Κριτικές
- Σχόλια
- Απαντήσεις
- Ερωτήσεις
Απαντήσεις
Ερ: what is the firmware version and how can it be upgraded?
Ερώτηση από BG573216171 επί 2021-03-02 20:34:13
Ερ: i cannot use in 30a circuit breaker?
Ερώτηση από BG135501148 επί 2021-09-01 01:17:00
mainframe You can. I am on a 16amp breaker and use this quite a bit. I usually go up setting 6 or 7 (current dial) because the wires do get hot if use it for a larger amount of welds. A few days ago i did a 5s16p pack on setting 6 with ~12 pulses and i had to let the welding wires cool down because they were too hot to hold comfortably.
Βοηθητικός (0)
Ερ: what size is the prop hub shaft? 5mm? 6mm?
Ερώτηση από Andy0679 επί 2021-08-08 17:43:55
mainframe 5mm on the SunnySky x2216-7 1400kv that was included in the pnp kit
Βοηθητικός (1)
mainframe is the answer a question?
Βοηθητικός (1)
mainframe they can work, it depends on the motor inside the shutter though.
Βοηθητικός (0)
mainframe They will not grow to be like the picture suggests, in fact it's very unlikely that they will even germinate.
Βοηθητικός (0)
mainframe technically it should. the voltage range covers eu and us. I think what eu refers to in this case is the size of the device as it fits perfectly into a European wall socket.
Βοηθητικός (0)
Ερ: will this work with an inductive sensor?
Ερώτηση από jere69420 επί 2020-04-12 19:51:06
mainframe Not the top layer no, as an inductive sensor relies on metal. A bltouch is not an inductive sensor, it is a touch sensor. Inductive and capactive sensors can detect surfaces without touching. In short, i would not recommend an inductive sensor with this as the results can be unreliable.
Βοηθητικός (1)
mainframe Yes, it can be upgrade by using Flash Multi (github, and the instructions on the website). This will rewrite the bootloader and a firmware of your choosing. i.e. aircraft, land etc. That's the easy way I found.
Βοηθητικός (1)