BG332373951
- Τα περιεχόμενα μου
- Όλα τα μηνύματα
- Κριτικές
- Σχόλια
- Απαντήσεις
- Ερωτήσεις
Απαντήσεις
Ερ: Hello, Is this cable create a paralell connection between the motors, or serial?
Ερώτηση από tsoft επί 2022-06-14 01:24:59
BG332373951 Itis parallel connection for 2 steppers to one board port.
Βοηθητικός (0)
Ερ: Any chance these work on Anycubic Mega Pro!?
Ερώτηση από MarckOliver επί 2022-10-18 03:41:26
BG332373951 I think not. One of silicon column is sorter than other 3.
Βοηθητικός (0)
Ερ: Can I run several LED strips off one WeMos board?
Ερώτηση από BG218056221 επί 2022-03-30 16:26:49
BG332373951 Yes you can if use external power supply for led strips. 5V pin of D1 mini is not capable to supply a led strip.
Βοηθητικός (0)
Ερ: Will this work with Alfawise U20 one?
Ερώτηση από Audenhuff επί 2021-01-17 01:05:26
BG332373951 Probablybut you have to check your board connections and your firmware. Will not work without proper firmware.
Βοηθητικός (0)
Ερ: Would this product be compatible with the geeetech a20m?
Ερώτηση από BG411723169 επί 2021-11-15 23:09:54
BG332373951 Seemsto be compatible. Same extruder kit, but you need to check your steps of extruder in firmware.
Βοηθητικός (0)
BG332373951 Yesit is compatible. Yes it needs firmware that will support BLTOUCH. No it is not plug and play. You need to look at github of BIGTREE. It has pictures for connections. You don't need ISP programmer and little board.
Βοηθητικός (0)
BG332373951 No you can not! For up to 3A you must use a LM2596 for step down (with heat sink) or XL5009 for step up (with heat sink)
Βοηθητικός (0)
BG332373951 If X axis is 2020 extrusion probably does. Be aware of timing belt length. Also you should look out of hot end compatibility
Βοηθητικός (1)