Όλα τα μηνύματα

QuadCore Ihad the same issue when I first used it. Later I removed the cover and noticed not all the screws holding the circuit board to the back plate (bottom cover) are tightened enough. So i tightened the screws so the power transistors get good plate connection for heat dispersion. Now it works as it should with just bit warm not hot.

Alfred Lalonde 18/03/2019
1
Σχόλια (1)

Ερ: I can not see the fan in your B6 mini

Ερώτηση από Sonroses επί 2018-06-23 05:45:24

QuadCore There are three screws inside the unit which holding the circuit board to the backplate. Make sure these are tightened so the power transistors get proper surface area to disperse the heat.

2019-06-04 02:49:52 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (2)

Ερ: I live in India so which mode should I choose NTSC or PAL

Ερώτηση από teevanshumalwa επί 2019-04-06 11:49:42

QuadCore Most Asian countries use PAL, but - unless you want to see the picture in an old TV - in practical terms it does not matter as it depends on what receiver you use. All modern receivers use both PAL and NTSC switchable.

2019-05-26 06:10:57 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (1)

pradeep You should be able to connect the transmitter to the 5v as it supports up to 1.5A. 3.3V may be too small to support the required power rating.

2019-05-13 08:07:33 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (5)