Όλα τα μηνύματα

Ερ: what are the 4 square pads on the controller board for?

Ερώτηση από luckstar επί 2018-08-25 03:57:40

bertoeless my guess would be output, input, voltage, ground, which goes to what you could see by looking at the traces on the board

2019-02-26 08:25:54 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (2)

bertoeless your shaft is loose, hold the bottom of the shaft against something hard and push the bell back down, then disassemble and loctite that sucker into place, if you don't disassemble the loctite will end up in the bearings, my 1104's do that in a hard crash and I just push em back up and keep flying then loctite later

Bonemyster 13/10/2017
3
Σχόλια (1)