Ph4nt0m
- Τα περιεχόμενα μου
- Όλα τα μηνύματα
- Κριτικές
- Σχόλια
- Απαντήσεις
- Ερωτήσεις
Απαντήσεις
Ερ: is this bore sighter fits in cal 30-06?
Ερώτηση από João Martins επί 2019-07-11 05:14:26
Ph4nt0m Hello,suitable for all sizes from 0.177 to 0.50 (diameter from 4.5 to 12.7 mm) only. Mine was not calibrated at all. Spotlight completely out of sync.
Βοηθητικός (0)
Ερ: is this compatible to 2017 Ford Fusion AWD Ecoboost Sedan?
Ερώτηση από jH0sH επί 2019-07-08 06:07:13
Ph4nt0m Hello,personally I had to sand this antenna to make it compatible with my toyota's roof (which is supposed to be compatible)! If your antenna connection is a threaded rod, you can give it a try. You just have to lightly sand the surfaces of this antenna to make it fit the car roof. If less than 1 mm, the sticker does the rest.
Βοηθητικός (0)
Ερ: Bonjour, is it waterproof? for snorkelling? Thank you
Ερώτηση από dhavydh επί 2017-11-26 14:02:43
Ph4nt0m Sorryno waterproof
Βοηθητικός (0)
Ερ: Is it possible to make adjustment to output voltage? I need 31-32V DC at output.
Ερώτηση από IvanS επί 2020-06-09 05:15:31
Ph4nt0m Hi, friend. Yes, it's possible. Two solutions for you (Elegant & Dirty). - Elegant: You have to modify one or more resistors to change the voltage of the feedback comparator. Need a technical sheet and a little bit of thinking. - Dirty : Add power diodes in series connection to reach 32V. Be careful, at full load it's 20W that dissipates in the diodes (most diodes have a voltage drop of 0.6V, on this basis 6 to 7 diodes are necessary, but this solution is really not clean or worthy of a modern power supply).
Βοηθητικός (0)
Ερ: does this set include the tri wing for iPhone 7, 8 & x?
Ερώτηση από jelassaad επί 2018-12-19 05:34:41
Ph4nt0m Hifriend. This set have only one tri wing, size 2.0.
Βοηθητικός (1)
Ερ: T8, T9, T10, T15 are security torx with hole?
Ερώτηση από BBR90 επί 2019-10-07 07:45:41
Ph4nt0m Hifriend. Yes, Torx 8,9,10,15 are with security hole.
Βοηθητικός (1)
Ph4nt0m Hi, I confirm also need to install driver CH340 or CH341. Be sure no device are unknown by OS, and normally you have new COM ports on your PC. Step: - Select correct Deep Switch on board (before power on). - Plug in USB cable and Power supply. - Use correct model and library with your Arduino IDE.
Βοηθητικός (3)