Nperez39
- Τα περιεχόμενα μου
- Όλα τα μηνύματα
- Κριτικές
- Σχόλια
- Απαντήσεις
- Ερωτήσεις
Απαντήσεις
Nperez39 Check the diode it probably blew out when hooked up wrong just check continuity
Βοηθητικός (0)
Nperez39 No need for that if you look on my profile you can see the layout on how I did it, just like the name rgb the first is red the next is blue then ground the green if you have a multimeter you can put it on diode setting and check from there in each pin
Βοηθητικός (1)
Ερ: Where's the clear common Anode leds?
Ερώτηση από SamR επί 2020-08-28 00:44:43
Nperez39 You will have to get a arduino or esp and play with the color sequence to find the clear mode
Βοηθητικός (0)
Nperez39 If you need a constant voltage try adding a mosfet7806 or 7807 before the lm2596
Βοηθητικός (0)Ερ: I'm looking for frosted RGB LEDs 5mm common cathode, do you sell them too?
Ερώτηση από Marco81K επί 2019-06-06 11:43:20
Nperez39 You can actually sand the led to make it look defused
Βοηθητικός (2)Ερ: What is the voltage of this led ?
Ερώτηση από BG817151744 επί 2020-08-05 08:33:10
Nperez39 Run your multimeter from a color pin to ground pin individually on diode mode to get accurate minimum voltage per led
Βοηθητικός (1)
Ερ: Which is the maximum output-power?
Ερώτηση από mga81 επί 2020-10-16 14:53:13
Nperez39 It claims to have an output of 40v but probably should not go there, I always use the 10% rule of staying under max voltage
Βοηθητικός (0)
Nperez39 The out put should never change regardless of input , unless you exceeded the input voltage and damaged the unit
Βοηθητικός (0)