kiwiMark This pumps tyres reasonably quickly at 16L per minute, if that is too slow for you then there is a bigger, heavier imars pump with 3 x 2,000mAh batteries (this one has 2 x 2,000mAh batteries) that pumps at 35L per minute. I have both pumps (as well as the Xiaomi and the Baseus) and this is my 2nd fastest with the bigger imars being my fastest pump. The bigger version is 25% more money, 60% heavier, quite a bit bigger - but it definitely pumps the air at a faster rate (pumping up tyres about twice as fast).

kiwiMark A barometer measures air pressure, therefore I would assume a baroceptor would be an air pressure measuring sensor.

kiwiMark I use the Perfect Squeeze mount - hold this phone very firmly. I will be using this phone with that mount on my motorcycle. Some other mounts wont hold the phone well because of the thickness of this phone, but the Perfect Squeeze works. I did disable the quick launch button in the settings so the mount can press on that button without a problem, on the other side the mount presses between the power button & fingerprint reader - I can still use both the fingerprint reader and the power button while this phone is in the Perfect Squeeze mount.

kiwiMark Turn on, touch probes to each side of the fuse - if the fuse is intact then the multi-meter would give a near zero resistance reading and start beeping. It is very clever in its ability to work out if there is a voltage differential or amps flowing or low resistance - exactly how it does it isn't important, the important thing is that it does work.

kiwiMark You could probably make it work, but I wouldn't buy this product if that was my goal. I'd say that the BlitzWolf BW-S15 is the better product for that task. This product can't deliver 5V 2A from both the USB 3 & 4 ports, so you'd have to only use one of them and maybe one of the USB1&2 ports and both the USB C ports. With the BW-S15 you could use 2 of the non-QC ports and both QC ports and it should be fine. The S15 doesn't do the weird turning on & off thing that the S16 does when you plug in another device.

kiwiMark The tape is marked in both m and in inches or feet. The readout from the Laser can be switched between metres and inches and feet with a long press on the U button. There are actually 6 options for units: 1. 0.000m (nearest mm) 2. 0.00m (nearest cm) 3. 0.0in (inches to the nearest tenth) 4. Inches to the nearest sixteenth 5. 0'00" + fraction (Feet, inches & fraction of an inch to nearest sixteenth) 6. 0.00ft (feet to the nearest hundredth of a ft)

kiwiMark Yes, the pouch holds the multimeter & test leads and a USB cable (for charging).

kiwiMark I tried 2 of my 32650 cells (slightly longer than D cells, but same diameter) and they don't quite fit in at the same time, it does charge 1 x D cell just fine though. This is with the 2-cell version. I can't charge D cells with my Xtar charger, so this Nitecore charger is definitely better.