Πολύ ωραίος Μηχανοδηγός για το Π-3. Λειτουργεί πολύ καλά στο ρομπότ DIY.

Very nice Motor Driver for Pi 3. Works very good in DIY robot.

Πολύ ωραίος Μηχανοδηγός για το Π-3. Λειτουργεί πολύ καλά στο ρομπότ DIY.

Εντάξει

ok

Εντάξει

Το καπέλο είναι εντάξει, αλλά θα ήταν πολύ χρήσιμοι και η τεκμηρίωση είναι πολύ δύσκολο να βρεθεί

The hat is ok but address jumpers would be very useful and documentation is very hard to find it would nice if it was included

Το καπέλο είναι εντάξει, αλλά θα ήταν πολύ χρήσιμοι και η τεκμηρίωση είναι πολύ δύσκολο να βρεθεί

These instructions are not sufficient for me to use this product

These instructions are not sufficient for me to use this product

These instructions are not sufficient for me to use this product

Using this with the Pi great for the purpose I needed it for

Using this with the Pi great for the purpose I needed it for

Using this with the Pi great for the purpose I needed it for

Exelente

Exelente

Exelente

havent used but well packed

havent used but well packed

havent used but well packed

Information on the board can be a bit hard to find, but it is out there. It is a nice board for controlling motors and servo's. This model does not have the stacking headers, so it is a bit harder to use more then one of them without either changing the hadder, or putting in jumpers for the I2C bus. The board does have solder pads to let you change the address of the board.

Information on the board can be a bit hard to find, but it is out there. It is a nice board for controlling motors and servo's. This model does not have the stacking headers, so it is a bit harder to use more then one of them without either changing the hadder, or putting in jumpers for the I2C bus. The board does have solder pads to let you change the address of the board.

Information on the board can be a bit hard to find, but it is out there. It is a nice board for controlling motors and servo's. This model does not have the stacking headers, so it is a bit harder to use more then one of them without either changing the hadder, or putting in jumpers for the I2C bus. The board does have solder pads to let you change the address of the board.

Have not tried it yet but hoping that I can find drivers for it soon.

Have not tried it yet but hoping that I can find drivers for it soon.

Have not tried it yet but hoping that I can find drivers for it soon.