I bougth 3 modules and all off them have a defect in the ipx conector that prevent to use and external antenna. Central pin of ipx connector is not connect to the board. De defect looks internal but I check with a tester. Please give a solution because my aplication need and external antenna otherwise is useless. Please dont ask for video o photo because it doesn't show externaly. Thanks

I bougth 3 modules and all off them have a defect in the ipx conector that prevent to use and external antenna. Central pin of ipx connector is not connect to the board. De defect looks internal but I check with a tester. Please give a solution because my aplication need and external antenna otherwise is useless. Please dont ask for video o photo because it doesn't show externaly. Thanks

I bougth 3 modules and all off them have a defect in the ipx conector that prevent to use and external antenna. Central pin of ipx connector is not connect to the board. De defect looks internal but I check with a tester. Please give a solution because my aplication need and external antenna otherwise is useless. Please dont ask for video o photo because it doesn't show externaly. Thanks

The GPS module uses the UBLOX NEO6M chip. The data sheet can be found here: https://www.u-blox.com/sites/default/files/products/documents/NEO-6_DataSheet_(GPS.G6-HW-09005).pdf I bought this module since it has an on-board antenna. I connected the module to an Arduino Uno and installed the tinygpsplus library. The library can be found here: http://arduiniana.org/libraries/tinygpsplus/ Connected TX to D4 and RX to D3. The only thing I had to do to make examples work was to change baud rate from 4800 to 9600. Works well.

The GPS module uses the UBLOX NEO6M chip. The data sheet can be found here: https://www.u-blox.com/sites/default/files/products/documents/NEO-6_DataSheet_(GPS.G6-HW-09005).pdf I bought this module since it has an on-board antenna. I connected the module to an Arduino Uno and installed the tinygpsplus library. The library can be found here: http://arduiniana.org/libraries/tinygpsplus/ Connected TX to D4 and RX to D3. The only thing I had to do to make examples work was to change baud rate from 4800 to 9600. Works well.

The GPS module uses the UBLOX NEO6M chip. The data sheet can be found here: https://www.u-blox.com/sites/default/files/products/documents/NEO-6_DataSheet_(GPS.G6-HW-09005).pdf I bought this module since it has an on-board antenna. I connected the module to an Arduino Uno and installed the tinygpsplus library. The library can be found here: http://arduiniana.org/libraries/tinygpsplus/ Connected TX to D4 and RX to D3. The only thing I had to do to make examples work was to change baud rate from 4800 to 9600. Works well.