Πολύ καλός ελεγκτής πτήσης!

Very good flight controller!

Πολύ καλός ελεγκτής πτήσης!

Φαίνεται καλής ποιότητας.

Looks good quality.

Φαίνεται καλής ποιότητας.

Δεν δοκιμάσαμε ακόμα. Γρήγορη αποστολή.

Looks good. Not tried yet. Fast shipping. Thanks.

Δεν δοκιμάσαμε ακόμα. Γρήγορη αποστολή.

Ωραίο FC με προσθήκη βαρό και φλας για το μαύρο κουτί, πολλές βελανιδιές διαθέσιμες και βασικές οπές σε PCB σε καλώδια κλωστής πριν από την συγκόλληση, πράγμα που το κάνει τόσο πολύ πιο εύκολο να συνδεθεί. Έχει μια ειδική συσκευή για το TX5 για GPS και δουλεύει και με την μονάδα αέρα Κάντιξ/DJI. Ένα μικρό αντίγραφο εντοπίζει το PCB που στάλθηκε με όλες τις καρφίτσες που είναι χρήσιμες και κάνουν μια αξιοπρεπή προσθήκη στο κλειδί μετά. Χρησιμοποιήσαμε δύο μέχρι τώρα και πιθανότατα θα αγοράσουμε ένα άλλο για να αντικαταστήσουμε τα βασικά Τyro Fcs με κάτι πολύ, πολύ καλύτερο. Η μόνη απογοήτευση είναι ότι δεν μπορώ να δω το λογισμικό INAV γι' αυτό, πράγμα που θα το έκανε ένα πολύ ολοκληρωμένο ανθρωπάκι! Επίσης πρέπει να δώσω μια κραυγή στο Jemhu(?) 20 εσκούδος με τις ίδιες τρύπες για συρματόπλεγμα

Nice FC with addition of baro and flash for blackbox, lots of uarts available and essential holes in PCB to thread wires before soldering which makes it sooooo much easier to get wired up. Has a dedicated pin out on TX5 for GPS and works with Caddix/DJI air unit as well. Great little replica pin out PCB sent as well with all pins labelled that's both useful and make a decent keyring addition afterwards. Have used two so far and will likely buy another to replace basic tyro low end fcs with something much, much better. Only disappointment is no INAV firmware I can see for this yet which would make it a very complete little fellow! Also have to give a shout out to jemchu(?) 20 esc board with same holes for wire threading

Ωραίο FC με προσθήκη βαρό και φλας για το μαύρο κουτί, πολλές βελανιδιές διαθέσιμες και βασικές οπές σε PCB σε καλώδια κλωστής πριν από την συγκόλληση, πράγμα που το κάνει τόσο πολύ πιο εύκολο να συνδεθεί. Έχει μια ειδική συσκευή για το TX5 για GPS και δουλεύει και με την μονάδα αέρα Κάντιξ/DJI. Ένα μικρό αντίγραφο εντοπίζει το PCB που στάλθηκε με όλες τις καρφίτσες που είναι χρήσιμες και κάνουν μια αξιοπρεπή προσθήκη στο κλειδί μετά. Χρησιμοποιήσαμε δύο μέχρι τώρα και πιθανότατα θα αγοράσουμε ένα άλλο για να αντικαταστήσουμε τα βασικά Τyro Fcs με κάτι πολύ, πολύ καλύτερο. Η μόνη απογοήτευση είναι ότι δεν μπορώ να δω το λογισμικό INAV γι' αυτό, πράγμα που θα το έκανε ένα πολύ ολοκληρωμένο ανθρωπάκι! Επίσης πρέπει να δώσω μια κραυγή στο Jemhu(?) 20 εσκούδος με τις ίδιες τρύπες για συρματόπλεγμα

schnell geliefert, gute Qualität.

schnell geliefert, gute Qualität.

schnell geliefert, gute Qualität.

This could be the best flight controller,, but... 1) The BOOT button did not work for me (The device was not even listing in the devices in windows) -I have investigated this and fiound out that the button must pull BOOT0 pin of the MCU to VDD, but when the FC is connected to the usb, there is no 3.3v on the other side of the button. 2) There is no INAV build for this FC. -I have tried the one for MATEKF405-SE and it bricked my Baro. (Actually, the rest was working not sure if UARTS are in the right order as on PCB) 3) After I have reflashed to BF, the baro is not working anymore. 4) The support chat of the facebook group of SKYSTARS answers to do the things that i have already did despite that i have descrbed the problem and I am not a total newbie. 5) SKYSTARS website downloads page leads to nowhere so they even not giving pin definitions or a complete BF build for the FC. Overall it is very very very good quality soldered pcb, it is nice and tiny, it has baro and many uarts. It could have been the best flight controller for the price.

This could be the best flight controller,, but... 1) The BOOT button did not work for me (The device was not even listing in the devices in windows) -I have investigated this and fiound out that the button must pull BOOT0 pin of the MCU to VDD, but when the FC is connected to the usb, there is no 3.3v on the other side of the button. 2) There is no INAV build for this FC. -I have tried the one for MATEKF405-SE and it bricked my Baro. (Actually, the rest was working not sure if UARTS are in the right order as on PCB) 3) After I have reflashed to BF, the baro is not working anymore. 4) The support chat of the facebook group of SKYSTARS answers to do the things that i have already did despite that i have descrbed the problem and I am not a total newbie. 5) SKYSTARS website downloads page leads to nowhere so they even not giving pin definitions or a complete BF build for the FC. Overall it is very very very good quality soldered pcb, it is nice and tiny, it has baro and many uarts. It could have been the best flight controller for the price.

This could be the best flight controller,, but... 1) The BOOT button did not work for me (The device was not even listing in the devices in windows) -I have investigated this and fiound out that the button must pull BOOT0 pin of the MCU to VDD, but when the FC is connected to the usb, there is no 3.3v on the other side of the button. 2) There is no INAV build for this FC. -I have tried the one for MATEKF405-SE and it bricked my Baro. (Actually, the rest was working not sure if UARTS are in the right order as on PCB) 3) After I have reflashed to BF, the baro is not working anymore. 4) The support chat of the facebook group of SKYSTARS answers to do the things that i have already did despite that i have descrbed the problem and I am not a total newbie. 5) SKYSTARS website downloads page leads to nowhere so they even not giving pin definitions or a complete BF build for the FC. Overall it is very very very good quality soldered pcb, it is nice and tiny, it has baro and many uarts. It could have been the best flight controller for the price.

What an awesome little FC the 10volt bec is very helpful with the Rush tank mini. Very clean no noise on the VTX. Super happy.

What an awesome little FC the 10volt bec is very helpful with the Rush tank mini. Very clean no noise on the VTX. Super happy.

What an awesome little FC the 10volt bec is very helpful with the Rush tank mini. Very clean no noise on the VTX. Super happy.