Όλα τα μηνύματα

Ερ: Will this work with 110volts also?

Ερώτηση από BG224216171 επί 2024-07-11 01:59:46

AresFPV the heater only runs off 12v. with the correct AC transformer wire, it would be able to run 110v. uk plug is a 240v to 12v transformer. you would need a 110v to 12v transfer with the correct plug at the heater end

2024-11-22 12:03:25 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (1)
19josh98creator 26/12/2020
36
Συστάσεις
Σχόλια (7)

Ερ: What is the exact diameter of the motor/spindle shaft?

Ερώτηση από o0AKB0o επί 2020-10-13 04:32:34

AresFPV 8mm

2024-06-16 10:29:02 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (3)

Ερ: how do you connect 2 motors for a tank with this?

Ερώτηση από highwayman επί 2023-12-12 10:53:17

AresFPV you will need 2 escs for 2 different motors. pretty sure this only has one motor output

2024-06-16 10:27:55 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (1)

Ερ: does this Rx work with low voltage servo? If the input vikty is 1S lipo (3.7v-4.2v)

Ερώτηση από KLKOK επί 2018-09-12 01:18:40

AresFPV yes should work fine but as you said it will need a power input

2023-01-07 02:10:04 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (4)

Ερ: Is this DSMX/DSM2 compatible?

Ερώτηση από gjadam1 επί 2021-05-02 02:24:15

AresFPV no it is not. it uses the afhds 2a protocol

2023-01-07 02:09:24 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (2)

Ερ: can this be used in EU (italy) ?

Ερώτηση από Yexel επί 2018-01-04 06:58:52

AresFPV should be ok as its a 2.4ghz system

2023-01-07 02:06:36 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (3)

Ερ: what is working distance between receiver and remote control

Ερώτηση από BG539185151 επί 2021-11-18 02:20:28

AresFPV average around 400m maximum I expect

2022-11-05 11:46:34 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (2)

Ερ: Can this be used in the uk? The nominal voltage here is 230v

Ερώτηση από BG564816174 επί 2020-04-17 07:09:06

AresFPV yes the power supply is configured for 230v

2022-11-05 11:45:28 Βοηθητικός (1)
υποβάλλουν
Απαντήσεις (8)

Ερ: can it get stuck at customs in India???

Ερώτηση από Chaitany επί 2020-04-08 12:31:00

AresFPV not sure. may be best to contact BG directly

2022-07-22 04:19:28 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (2)

Ερ: Can I use the bn-880 with that mount?

Ερώτηση από M0CKY επί 2020-06-22 09:08:43

AresFPV I think the 880 is a bit too large, the antenna would not fit with the lip around the mount. it may be possible for it to fit with slight modification to the mount, but this gps module is just slightly larger

2022-07-22 04:18:45 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (2)

AresFPV it could be you have selected the wrong communication method, this should be pwm for this receiver, that or it did not bind correctly. having a correct binding should show the voltage of the receiver on the transmitters screen

2022-07-05 04:14:29 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (2)

Ερ: Can it mill Aluminum ?

Ερώτηση από Aboelenein επί 2018-11-29 06:36:33

AresFPV yes. i suggest using single flute endmill for ali

2022-06-22 03:00:05 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (4)

Ερ: Can this Rx FS2A be binded with a Turnigy 9X V2 AFDHS2A ?

Ερώτηση από claudycharlier επί 2020-12-05 10:03:08

AresFPV yes the 9xv2 with the afhds2a module will bind as the protocols are the same

2022-05-29 11:26:50 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (2)

Ερ: Is there a wiring diagram available?

Ερώτηση από kechols_jr επί 2020-04-22 03:19:04

AresFPV fairly simple to wire, power is positive to the fused side i believe, motor doesnt matter as the wires can easily be swapped if the motor spins the wrong way. switch is used to turn on or off the motor separately or through a control board.

2022-05-29 11:13:47 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (2)

Ερ: How do I power up the unit? It is DC right? Difficult to find a DC power converter with 30 Volts

Ερώτηση από flowin_through επί 2021-04-07 10:14:27

AresFPV the power supply is connected to mains AC. there is no earth connection, but you can add one to the motor and or the power supply for safety

2022-05-29 11:11:03 Βοηθητικός (0)
υποβάλλουν
Απαντήσεις (2)