Όλα τα μηνύματα

Ερ: can I use two kits to expand both x and y to 900mm by 900mm?

Ερώτηση από sol1821 επί 2022-01-29 11:59:20

hawkt45 No,there is more to doing this. There is only one stepper motor on the X-axis and there is a steel shaft, which connects the pulley, to the belt. So no stepper motor on this side. Then the shaft is too short and it must be supported too. You would have to add a bearing or bushing, to the middle of the shaft. You will have to make your own extension cable too, because it must be double its length.

2022-02-03 02:34:02 Βοηθητικός (2)
υποβάλλουν
Απαντήσεις (2)

sol1821 just asked the same question then realised you'd need to extend the rail the laser runs on if expending both x and y

2022-01-29 12:01:43 Βοηθητικός (4)
υποβάλλουν
Απαντήσεις (2)