3 τεμάχια 1M σωλήνα Bowden από PTFE για εκτυπωτή 3D Reprap με νήμα 1,75 χιλιοστών
Ένα μέρος της κριτικής έχει μεταφραστεί αυτόματα.
Parfait pour déporter le moteur d'un extrudeur.
correspond au déscriptif
the PTFE tube itself is fine, comes with 2 push fit ends aprox m10 thread. so glad I also ordered some m5 push ends. where i was disappointed was the packing, it comes coiled to a diameter of aprox 100mm which is bad enough, but then the ends were wrapped through the coil , causing the whole length to take a spiral form, the worst of which suspending with a weight on the end for a day or 2 managed to remove. so usable but a bit kinky
Σύμφωνα με τις προδιαγραφές
Εξαιρετική ποιότητα, έλαβα αυτό που περίμενα, ωστόσο πιστεύω ότι για ένα άτομο σαν εμένα που έχει μόνο δύο εκτυπωτές είναι πολλά ανταλλακτικά, αλλά ποτέ δεν είναι πολλά. Έξοχα Καλιδάδ, recibi to que esperaba, αμάρτημα εμπάργκο Creo que una προσωπικόa coo y que tengo solo 2 ιμπρεσόρας es mο reuesto, "Πέρο Νούνκα" "Δέμα".
Απλά πολύ καιρό αλλά εντάξει
very Good
Γρήγορη παράδοση
As described...
Το έχω, αλλά μην το χρησιμοποιήσεις ακόμα.