Γεια σας, υπάρχει ένα μεγάλο πρόβλημα με τους κωδικοποιητές. Οι 10 κωδικοποιητές που έλαβα δεν έχουν κλωστές για να παραλάβουν τα παξιμάδια που θα τοποθετηθούν σε μια υπόθεση (βλ. φωτογραφίες σε συνημμένα αρχεία)!

Hello, There is a big problem with the encoders. The 10 encoders that I have received do not have threads to receive the nuts to be fixed on a case (see photos in attached files). Is it possible to exchange them? Thanks!

Γεια σας, υπάρχει ένα μεγάλο πρόβλημα με τους κωδικοποιητές. Οι 10 κωδικοποιητές που έλαβα δεν έχουν κλωστές για να παραλάβουν τα παξιμάδια που θα τοποθετηθούν σε μια υπόθεση (βλ. φωτογραφίες σε συνημμένα αρχεία)!

Всё чаще возникает необходимость в энкодерах к микроконтроллерам.

Всё чаще возникает необходимость в энкодерах к микроконтроллерам.

Всё чаще возникает необходимость в энкодерах к микроконтроллерам.

Nice reusable package. Works nice, all good. Amazing delivery speed - only two weeks from China to Europe!!!

Nice reusable package. Works nice, all good. Amazing delivery speed - only two weeks from China to Europe!!!

Nice reusable package. Works nice, all good. Amazing delivery speed - only two weeks from China to Europe!!!

Used as the frequency and mode select on my DDS VFO for my Direct Conversion Receiver

Used as the frequency and mode select on my DDS VFO for my Direct Conversion Receiver

Used as the frequency and mode select on my DDS VFO for my Direct Conversion Receiver

I tested with my Raspberry Pi and Arduino as well. It works perfectly! Note that GND and + leads are obvious but you have to know MS means the tactile switch, DATA and CLK are the two data lines where you have to put a data change interrupt to capture their signal raise and fall event.

I tested with my Raspberry Pi and Arduino as well. It works perfectly! Note that GND and + leads are obvious but you have to know MS means the tactile switch, DATA and CLK are the two data lines where you have to put a data change interrupt to capture their signal raise and fall event.

I tested with my Raspberry Pi and Arduino as well. It works perfectly! Note that GND and + leads are obvious but you have to know MS means the tactile switch, DATA and CLK are the two data lines where you have to put a data change interrupt to capture their signal raise and fall event.

Great. They came with washers and nuts.

Great. They came with washers and nuts.

Great. They came with washers and nuts.

Muy buen producto, excelente calidad.

Muy buen producto, excelente calidad.

Muy buen producto, excelente calidad.

Excelente, muy buen precio

Excelente, muy buen precio

Excelente, muy buen precio

It works great. Quality product.

It works great. Quality product.

It works great. Quality product.

Great, will buy again.

Great, will buy again.

Great, will buy again.